A.1. RealView Trace and RealView ICE
The RealView Trace analyzer is available from ARM® Limited. When used with RealView
ICE, it forms a complete trace solution. You connect it to your
development board using the supplied ribbon cable and adaptor, and
to the host workstation using a 10BaseT ethernet cable.
To set up your hardware to enable tracing in RealView Debugger as
shown in Figure A.1, connect
and configure the RealView ICE and RealView Trace units.
Note
If the target buffer board contains a 20-way JTAG IDC connector,
it is suggested that you use it. However, if the target board has
only a Mictor socket, and no JTAG IDC socket, then you must use
the JTAG IDC socket on the target buffer board.
PDF version