RealView Debugger Trace User Guide: B.3.1. Configuring your CoreSight development platform

To configure your CoreSight development platform to capture trace from the CoreSight ETM:

Install RealView ICE and connect up the hardware
Note
The RealView Trace software is included with RealView Debugger, and does not require a separate installation.
Select Start → Programs → ARM → RealView Development Suite v4.0 → RealView Debugger v4.0 to start RealView Debugger.
Configure RealView ICE to identify the processors and CoreSight components on your development platform.
Note
If your development platform has multiple trace sources, then you must add the CoreSight Trace Funnel (CSTFunnel).
Select Registers from the View menu to display the Registers view.
If your development platform has multiple trace sources, then you must configure the CoreSight Trace Funnel to identify the source from which trace is to be captured:
1. Connect to the CSTFunnel_n target.
2. Set up the Trace Funnel registers.
Note
If your development platform contains multiple processors and multiple ETMs, only one CoreSight ETM at a time can be chosen as the trace source in this release.
Configure the CoreSight ETM registers:
1. Connect to the CSETM_n target.
2. Set up the CSETM registers. Figure B.3 shows an example.
Figure B.3. CSETM registers in the Registers view
Configure the CoreSight Trace Port Interface Unit (TPIU) registers:
1. Connect to the CSTPIU_n target.
2. Set up the TPIU registers. Figure B.4 shows an example.
Figure B.4. CSTPIU registers in the Registers view
Connect to the target processor on your development platform.
Connect to the TPA.
Configure the ETM.

Copyright © 2006-2009 ARM Limited. All rights reserved.	ARM DUI 0322D
Non-Confidential
PDF version