| Copyright © 2006-2011 ARM. All rights reserved. | ARM DUI 0322G |
| Non-Confidential | ID052111 |
 PDF version | |
| Home > Configuring the ETM > Equivalent ETM_CONFIG CLI command qualifiers |
| |||
| Home > Configuring the ETM > Equivalent ETM_CONFIG CLI command qualifiers | |||
Table 4.1 shows the Configure ETM dialog box settings and the equivalent qualifiers to use with the ETM_CONFIG command to perform the same function in the CLI.
Table 4.1. ETM Configuration settings to command qualifier mapping
| Configure ETM dialog box setting | Command qualifier |
|---|---|
Trace data widths:
| port_width:0 port_width:1 port_width:2 port_width:3 port_width:4 |
Trace port modes (non-v3 architecture):
| nomultiplex multiplex demultiplex |
Trace port modes (ETMv3 only), of the
form
| portratio:0 portratio:1 portratio:2 portratio:3 portratio:4 portratio:5 portratio:6 |
| Half-rate clocking enabled | half_rate |
| Disable traceport | disableport |
Trace buffer packing:
| packauto packnormal packdouble packquad |
FIFO overflow protection:
| stall_full suppressdata FIFO_hw: |
Trace coproc register transfer:
| coprocessor filtercoprocessor |
Extended external input selection (ETMv3.1 and later):
The number of inputs available depends on your ETM configuration. |
|
| Memory map decode | mmap_decode:n |
| Synchronization frequency | syncfrequency: |
| Enable Timestamping | time_stamps |
| Cycle-accurate tracing | cycle_accurate |
| Data only trace (Do not trace instructions) | dataonly |
| Suppress data on FIFO full | datasuppression |
See also:
the following in the Command Line Reference Guide:
| Copyright © 2006-2011 ARM. All rights reserved. | ARM DUI 0322G |
| Non-Confidential | ID052111 |
| PDF version | |
| Home > Configuring the ETM > Equivalent ETM_CONFIG CLI command qualifiers |