| Copyright © 2006-2010 ARM Limited. All rights reserved. | ARM DUI 0323F |
| Non-Confidential | ID102410 |
 PDF version | |
| Home > Connecting to a Target and Loading an Image > Connecting to a running target > Before you start |
| |||
| Home > Connecting to a Target and Loading an Image > Connecting to a running target > Before you start | |||
If you want to connect to a running target, or disconnect
from a target without stopping the application, use the Connect_mode and Disconnect_mode configuration
settings as described in Procedure for configuring the connect
and disconnect settings.
Before connecting to a running target, make sure that the endianness in the connection properties matches the endianness of the target. If it does not, you might see the following error messages:
Error V2001B (Vehicle): Cannot set break on non-instruction boundary Error: Unable to detect endianness of target.
Procedure for configuring the connect and disconnect settings
the following in the RealView Debugger User Guide:
the following in the RealView Debugger Target Configuration Guide:
| Copyright © 2006-2010 ARM Limited. All rights reserved. | ARM DUI 0323F |
| Non-Confidential | ID102410 |
| PDF version | |
| Home > Connecting to a Target and Loading an Image > Connecting to a running target > Before you start |