Recreating a stitched system from exported configuration files

Note

  • You must have the IP bundle and appropriate versions of AMBA Designer and other EDA tools installed on the system on which you want to recreate the stitched system from configuration files.

  • You cannot use the render.csh script to rerender components that have not been originally rendered in AMBA Designer, even if they were used in a system. Reconfigure such systems outside AMBA Designer, and then add them to the Component Library.

  1. Run the render.csh script by specifying a destination directory for the design as a command-line argument:

    render.csh <SysName>_config <target_directory>
    

    The full hierarchical system is recreated in the target directory.

  2. Open the system in AMBA Designer:

    adcanvas <SysName>_config/<SysName>.adg
    
  3. You can now use and modify the system in AMBA Designer.

Show/hideSee also

Tasks
  • For instructions and prerequisites for a particular IP bundle, see the relevant Supplement documents to the AMBA Designer User Guide.

  • For information on which tools are required for a particular IP bundle, see the Release Note for the IP bundles.

  • For information about the tool versions that you require for a particular AMBA Designer release, see the AMBA Designer ADR-400 Release Note.

  • AMBA Designer ADR-400 Installation Guide

  • Starting AMBA Designer Canvas.

  • Adding a component to the default Component Library from the command line

Reference
Copyright © 2006-2013 ARM. All rights reserved.ARM DUI 0333N
Non-ConfidentialID051113