Component ports

Note

AMBA Designer does not support IP-XACT Phantom ports.

AMBA Designer supports the following port types:

Ports can be master or slave ports. Master bus interface ports always point out of the component, output ports, and slave interface bus ports always point into the component, input ports.

Figure 26 shows an example for each component port type as a master and a slave, respectively.

Figure 26. Component port types

Component port types

You can move component ports around the edges of the component.

Table 10 describes the color scheme used in AMBA Designer Canvas for component ports.

Table 10. Port colors

Color

Component type or visibility in the Canvas

Yellow

APB

Blue

AXI

Dark green

Unhidden disabled port

Light green

Tied-off input port

Black

General port color that AMBA Designer uses if there is no color reserved for the type or status


Show/hideSee also

Copyright © 2006-2013 ARM. All rights reserved.ARM DUI 0333N
Non-ConfidentialID051113