AMBA Designer workflow

This section describes the general flow for configuring components and creating systems. Peripherals and interconnects in SoC systems are highly configurable. To speed up the flow, consider the component and interconnect configurations that you might require before you use the tools.

Prerequisites

Figure 1 shows a typical design flow when you use AMBA Designer Canvas. The overall workflow is the same for AMBA 2, AMBA 3, and AMBA 4 components.

Figure 1. Design flow with AMBA Designer Canvas

To view this graphic, your browser must support the SVG format. Either install a browser with native support, or install an appropriate plugin such as Adobe SVG Viewer.


You can configure all components with AMBA Designer in the following ways:

Note

You can only configure one component at a time both in the Canvas and in batch mode. In batch mode, you can use the XML configuration file from the command line or in scripts. However, batch mode only configures one component at a time.

Show/hideSee also

Tasks
Copyright © 2006-2013 ARM. All rights reserved.ARM DUI 0333N
Non-ConfidentialID051113