Viewing the IP-XACT properties of a component

You can inspect the IP-XACT properties of a configured component in AMBA Designer:

  1. Right-click the component in the Component Window and select IP-XACT Properties....

  2. Use the following tabs to inspect the IP-XACT parameter settings:

    Bus Interfaces

    Generic properties and bus signals for each bus.

    Parameters

    Top-level or component IP-XACT parameters.

    Note

    You cannot modify these parameters from the IP-XACT Properties dialog. If you require different top-level parameters, you must reconfigure the component or create a new component configuration.

    Signals

    Signal name, direction, left and right connection widths, the export state, and whether the signal is assigned to a bus interface.

    Check the Show Unassigned Signals Only option to show unassigned signals only in the dialog box.

  3. Click OK to close the dialog.

Show/hideSee also

Copyright © 2006-2013 ARM. All rights reserved.ARM DUI 0333O
Non-ConfidentialID092413