4.5. Reprogramming the PLD

The Logic Tile is supplied with the PLD already programmed. The information in this section is provided, however, in case of accidental erasure of the PLD.

Caution

You are advised not to reprogram this device with any images other than those provided by ARM Limited.

Program the PLD as follows:

  1. Put the Logic Tile into Configuration mode by fitting the CONFIG link or switch on the baseboard or Interface Module and power-up.

  2. Run the Progcards utility. All .brd files present in the current directory that match the TAP configuration are offered as options. Select one of the options.

  3. Choose the required PLD image.

Copyright © 2006-2008 ARM Limited. All rights reserved.ARM DUI 0345D
Non-Confidential