A.3. Mechanical details

Figure A.2 shows the mechanical outline of the Logic Tile. The position of the two mounting holes and of pin 1 on the Samtec connectors are indicated.

Note

The PCB Gerber files are available from the ARM website at: www.arm.com/support/downloads/versatile.html

Figure A.2. Board outline

Table A.6 lists the Samtec part numbers and Table A.7 lists the mating heights for each part number extension.

Note

Samtec describes the QTH connector (used on the upper side of the tile) as a header and the QSH connector (used on the lower side of the tile) as a socket.

Table A.6. Samtec part numbers

HeaderPart number
HDRXUQTH-090-02-F-D-A-K
HDRXLQSH-090-01-F-D-A-K
HDRYUQTH-090-02-F-D-A-K
HDRYLQSH-090-01-F-D-A-K
HDRZUQTH-150-02-F-D-A-K
HDRZLQSH-150-01-F-D-A-K

Table A.7. Samtec part number and mating heights

Part number (for QTH)Mating height
-01-5mm
-02-8mm
-03-11mm
-04-16mm
-05-19mm
-06-22mm
-07-25mm
-08-30mm

Note

Logic Tiles use the -02- connectors on the upper side of the board and have 8mm board separation to the tile above. The Logic Tiles have a maximum component height of 2.5mm on the bottom and 5mm on the top of the board. This ensures that there are no component interference problems with mated boards.

Copyright © 2006-2008 ARM Limited. All rights reserved.ARM DUI 0345D
Non-Confidential