3.9. Edit Connection dialog

To change the connected port or the address mapping, select a connection from the Port Properties dialog and click Edit Connection.... The resulting dialog, shown in Figure 3.22, has the following controls:

Component

The source component if a slave port was displayed in the Port Properties dialog or the destination component if a master port was displayed in Port Properties.

Port

The master port for the connection if a slave port was displayed in the Port Properties dialog or the slave port for the connection if a master port was displayed in Port Properties.

Array index

If the port selected in the Port field is a port array, enter an index value to specify which of the elements of the array is used for the connection.

Enable address mapping

If this box is checked, the port address range is determined by the values in the Start and End boxes.

Start

The start address port the port.

End

The end address for the port.

Size

The size of the address region. If the Start and End values are entered, this value is calculated automatically. If the Size value is entered, the End value is calculated automatically.

OK/Cancel

After specifying the port and address, click OK to modify the connection. Click Cancel to close the dialog without changing the connection.

Figure 3.22. Add/Edit Connection Mapping dialog

Add/Edit Connection Mapping dialog

The LISA statement field shows the code that matches the entered address ranges.

Copyright © 2007-2009 ARM Limited. All rights reserved.ARM DUI 0370H
Non-Confidential