4.5. Add Connection dialog

The Add Connection dialog enables adding a connection to a component port. To display the dialog in Figure 4.5:

The enabled fields for the dialog depend on whether a slave or master was displayed in the Port Properties dialog. The controls are the same as the Edit Connection dialog but this dialog adds a new connection instead of modifying an existing connection. See Edit Connection dialog.

Note

This dialog is also displayed if the cursor is used in connect mode to connect two ports in the Block Diagram area and one or more of the ports is a port array.

Figure 4.5. Add Connection dialog

Add Connection dialog

Copyright © 2007-2010 ARM Limited. All rights reserved.ARM DUI 0370K
Non-ConfidentialID110210