2.12.2. Configuring the networking environment

Using System Canvas or a related Fast Models tool, load the required project or model and select your component. For more information, see the Fast Models User Guide.

Set the following parameters on the HostBridge and SMSC_91C111 components. Enter:

hostbridge.interfacename="ARM<x>"
smsc_91c111.enabled=1

where ARM<x> is the adapter built into the network bridge.

Note

The above has not been tested with wireless network adapters.

Note

If you need to enable promiscuous mode for the TAP device, you must set an additional parameter on the device. To do this:

  1. Select Start → Run → cmd.exe

  2. Enter:

    netsh bridge show adapter
    netsh bridge set adapter <N> forcecompatmode=enable
    

    where <N> is the id number of the TAP adapter listed by the first command.

Copyright © 2007-2010 ARM Limited. All rights reserved.ARM DUI 0370K
Non-ConfidentialID110210