2.7.2. Connecting the Trace Port Analyzer to the baseboard

For RealView Trace, connect the TPA to the adaptor board and plug the adaptor into the Core Tile as shown in Figure 2.9. RealView Trace requires a RealView ICE JTAG unit connected to the baseboard. The Ethernet and power supply cables connect to the RealView ICE unit.

For Multi-Trace, connect the Trace Port Analyzer (TPA) to the buffer board and plug the adaptor into the Core Tile as shown in Figure 2.10. Multi-Trace requires a Multi-ICE JTAG unit.

Note

The high-density cable from the RealView ICE box requires a buffer board to connect to the JTAG connector on the baseboard.

The low-density cable can be used to connect the RealView ICE box directly to the baseboard JTAG connector, but this interface operates at lower speed.

Figure 2.9. Trace connection with RealView Trace

Trace connection with RealView Trace

Figure 2.10. Trace connection with Multi-Trace

Trace connection with Multi-Trace

Copyright © 2005-2011 ARM Limited. All rights reserved.ARM DUI 0411D
Non-Confidential