A.11.4. Trace connector pinout

Table A.17 and Table A.18 list the pinout of the trace connector J49, tile site 1, and J50, tile site 2. The Mictor connector (part number AMP 2-767004-2) is shown in Figure A.17.

Note

Connectors J49 and J50 can be used as trace connectors for Logic Tiles that contain an implementation of a processor. If the Logic Tile does not contain a processor design, the FPGA might output debug signals on the connectors.

For Core Tiles, use the trace connectors on the tile.

Agilent, formerly HP, and Tektronix label these connectors differently, but the assignments of signals to physical pins is appropriate for both systems and pin 1 is always in the same place. The figure is labelled according to the Agilent pin assignment.

Figure A.17. AMP Mictor connector

AMP Mictor connector

Table A.17. Trace connector J49

ChannelPinPinChannel
Not connected12Not connected
GND34Not connected
T1Y17856T1Y179
T1Y17778T1Y168
T1Y152910T1Y167
T1Y1511112T1Y166
T1Y1501314T1Y165
T1Y1491516T1Y164
T1Y1481718T1Y163
T1Y1471920T1Y162
T1Y1462122T1Y161
T1Y1762324T1Y160
T1Y1752526T1Y159
T1Y1742728T1Y158
T1Y1732930T1Y157
T1Y1723132T1Y156
T1Y1713334T1Y155
T1Y1703536T1Y154
T1Y1693738T1Y153

Table A.18. Trace connector J50

ChannelPinPinChannel
Not connected12Not connected
GND34Not connected
T2Y17856T2Y179
T2Y17778T2Y168
T2Y152910T2Y167
T2Y1511112T2Y166
T2Y1501314T2Y165
T2Y1491516T2Y164
T2Y1481718T2Y163
T2Y1471920T2Y162
T2Y1462122T2Y161
T2Y1762324T2Y160
T2Y1752526T2Y159
T2Y1742728T2Y158
T2Y1732930T2Y157
T2Y1723132T2Y156
T2Y1713334T2Y155
T2Y1703536T2Y154
T2Y1693738T2Y153

Copyright © 2005-2011 ARM Limited. All rights reserved.ARM DUI 0411D
Non-Confidential