Setting Streamline start and stop points

Streamline start and stop points are locations in source or assembly code that are used to enable or disable Streamline capture in a running application. A Streamline start and stop point is hit when the processor executes an instruction at a specific address.

Streamline start and stop points can be set from the following views:

To set a Streamline start and stop point, right-click in the left-hand marker bar at the position where you want to set the start and stop point and select either Toggle Streamline Start or Toggle Streamline Stop from the DS-5 Breakpoints context menu. To remove a start and stop point, repeat this procedure on the same start and stop point.

Show/hideSee also

Copyright © 2010-2012 ARM. All rights reserved.ARM DUI 0446K
Non-ConfidentialID071912