3.17 Configuring the debugger path substitution rules
During the debugging process, the debugger attempts to open the corresponding source file when execution stops at an address in the image or shared object.
The debugger might not be able to locate the source file when debug information is loaded because:
The path that is specified in the debug information is not present on your
workstation, or that path does not contain the required source file.
The source file is not in the same location on your workstation as the image
containing the debug information. The debugger attempts to use the same path
as this image by default.
Therefore, you must modify the search paths used by the debugger when it executes any of the commands that look up and display source code.
To modify the search paths:
Open the Path Substitution dialog
Click on the required toolbar icons in the Path
Substitution dialog box:
Figure 3-12 Path Substitution dialog box
Click OK to pass the substitution
rules to the debugger and close the Path
Substitution dialog box.