11.33 Watchpoint Properties dialog box

Use the Watchpoint Properties dialog box to display the properties of a watchpoint and to change the watchpoint type.

Figure 11-38 Watchpoint Properties dialog box
Watchpoint Properties dialog box

The following types are available:
READ
The debugger stops the target when the address is read from.
WRITE
The debugger stops the target when the address is written to.
ACCESS
The debugger stops the target when the address is read from or written to.
The following properties are displayed:
State
Indicates whether the watchpoint is valid or invalid. A watchpoint is invalid if it cannot be set for any reason. Typically this is because hardware resources have run out.
Enabled
Indicates whether the watchpoint is enabled or disabled.
Hardware Virtualization
Indicates whether Hardware Virtualization is supported.
Break on Virtual Machine ID
If Hardware Virtualization is supported, specify the Virtual Machine ID (VMID) of the guest operating system to which the watchpoint applies.
Non-ConfidentialPDF file icon PDF versionARM DUI0446W
Copyright © 2010-2015 ARM. All rights reserved.