4.9.3 Creating a standalone register

Describes how to create a basic standalone register.


  1. Click on the Registers tab.
  2. Enter the register data as shown in the following figure.
  3. Bitfield data is entered in a floating table associated with the selected register. Select the Unique name field containing the register name, BRD_SYS_LED.
  4. Click on the Edit Bitfield button in the top right corner of the view.
  5. In the floating Bitfield table, enter the data as shown in the following figure. If required, you can dock this table below the register table by clicking on the title bar of the Bitfield table and dragging it to the base of the register table.
    Figure 4-12 Creating a standalone register
    Creating a standalone register

On completion, close the floating table.
Related tasks
4.9.1 Creating a memory map
4.9.2 Creating a peripheral
4.9.4 Creating a peripheral register
4.9.5 Creating enumerations for use with a peripheral register
4.9.6 Assigning enumerations to a peripheral register
4.9.7 Creating remapping rules for a control register
4.9.8 Creating a memory region for remapping by a control register
4.9.9 Applying the map rules to the overlapping memory regions
Related reference
4.9 Scenario demonstrating how to create a new target configuration file
4.5 Target configuration editor - Registers tab
4.8 Target configuration editor - Configurations tab
Non-ConfidentialPDF file icon PDF versionARM DUI0446W
Copyright © 2010-2015 ARM. All rights reserved.