step

This command steps through an application at the source level stopping on the first instruction of each source line including stepping into all function calls. You must compile your code with debug information to use this command successfully.

You can modify the behavior of this command with the set step-mode command.

Show/hideSyntax

step [count]

Where:

count

Specifies the number of source lines to execute.

Note

Execution stops immediately if a breakpoint is reached, even if fewer than count source lines are executed.

Show/hideExample

Example 131. step

step                                  # Execute one source line
step 5                                # Execute five source lines

Show/hideSee also

Copyright © 2010 ARM. All rights reserved.ARM DUI 0452B
Non-ConfidentialID100410