silence

This command disables the printing of stop messages for a specific breakpoint.

Show/hideSyntax

silence [number]

Where:

number

Specifies the breakpoint number. This is the number assigned by the debugger when it is set. You can use info breakpoints to display the number and status of all breakpoints and watchpoints.

If no number is specified then all stop messages are disabled.

Show/hideExample

Example 135. silence

silence 2                          # Disable printing of stop messages for breakpoint 2

Show/hideSee also

Copyright © 2010, 2011 ARM. All rights reserved.ARM DUI 0452D
Non-ConfidentialID011411