set step-mode

This command controls the default behavior of the step and steps commands.

Show/hideSyntax

set step-mode { step-over | stop|step-until-source}

Where:

step-over

If the instruction is a function call then then the debugger performs a step-over. Otherwise, it stops. This is the default.

stop

The debugger stops when execution reaches an address with no source.

step-until-source

The debugger performs steps until it reaches source. To speed up the execution, the debugger might use abstract interpretation and break or run until the line of source is reached.

Show/hideExample

Example 106. set step-mode

set step-mode step-over             # Step over a function call and stop.
                                    # Otherwise stop

Show/hideSee also

Copyright © 2010, 2011 ARM. All rights reserved.ARM DUI 0452D
Non-ConfidentialID011411