next

This command steps through an application at the source level stopping at the first instruction of each source line but stepping over all function calls. You must compile your code with debug information to use this command successfully.

Show/hideSyntax

next [count]

Where:

count

Specifies the number of source lines to execute.

Note

Execution stops immediately if a breakpoint is reached, even if fewer than count source lines are executed.

Show/hideExample

Example 83. next

next                                  # Execute one source line
next 5                                # Execute five source lines

Show/hideSee also

Copyright © 2010, 2011 ARM. All rights reserved.ARM DUI 0452G
Non-ConfidentialID092311