break.disable

This command disables a breakpoint at the specified address.

Show/hideSyntax

break.disable expression

Where:

expression

Specifies the breakpoint address. This can be either an address, a symbol name, or an expression that evaluates to an address. You can use the syntax symbol\line to refer to a specific source line offset from a symbol.

Show/hideExample

Example 166. break.disable

break.disable 0x8000 ; Disable breakpoint at address 0x8000
break.disable main   ; Disable breakpoint at address of main()
break.disable main+4 ; Disable breakpoint 4 bytes after address of main()
break.disable main\2 ; Disable breakpoint 2 source lines after address of main()

Show/hideSee also

Copyright © 2010, 2011 ARM. All rights reserved.ARM DUI 0452H
Non-ConfidentialID111711