resolve

This command re-evaluates the specified breakpoints or watchpoints and those with addresses that can be resolve are set. Unresolved addresses remain pending.

Show/hideSyntax

resolve [number]...

Where:

number

Specifies the breakpoint or watchpoint number. This is the number assigned by the debugger when it is set. You can use info breakpoints to display the number and status of all breakpoints and watchpoints.

If no number is specified then all breakpoints and watchpoints are re-evaluated.

Show/hideExample

Example 94. resolve

resolve 1                      # Resolve breakpoint/watchpoint number 1
resolve 1 2                    # Resolve breakpoints/watchpoint number 1 and 2
resolve                        # Resolve all breakpoints/watchpoints

Show/hideSee also

Copyright © 2010, 2011 ARM. All rights reserved.ARM DUI 0452H
Non-ConfidentialID111711