steps

This command steps through an application at the source level stopping on the first instruction of each source statement (for example, statements in a for() loop) including stepping into all function calls. You must compile your code with debug information to use this command successfully.

You can modify the behavior of this command with the set step-mode command.

Show/hideSyntax

steps [count]

Where:

count

Specifies the number of source statements to execute.

Note

Execution stops immediately if a breakpoint is reached, even if fewer than count source statements are executed.

Show/hideExample

Example 150. steps

steps                              # Execute one source statement
steps 5                            # Execute five source statements

Show/hideSee also

Copyright © 2010, 2011 ARM. All rights reserved.ARM DUI 0452H
Non-ConfidentialID111711