nexts

This command steps through an application at the source level stopping at the first instruction of each source statement but stepping over all function calls. You must compile your code with debug information to use this command successfully.

Show/hideSyntax

nexts [count]

Where:

count

Specifies the number of source statements to execute.

Note

Execution stops immediately if a breakpoint is reached, even if fewer than count source statements are executed.

Show/hideExample

Example 85. nexts

nexts                                  # Execute one source statement
nexts 5                                # Execute five source statements

Show/hideSee also

Copyright © 2010, 2011 ARM. All rights reserved.ARM DUI 0452H
Non-ConfidentialID111711