unsilence

This command enables the printing of stop messages for a specific breakpoint.

Show/hideSyntax

unsilence [number]

Where:

number

Specifies the breakpoint number. This is the number assigned by the debugger when it is set. You can use info breakpoints to display the number and status of all breakpoints and watchpoints.

If no number is specified then all stop messages are enabled.

Show/hideExample

Example 152. unsilence

unsilence 2                      # Enable printing of stop messages for breakpoint 2

Show/hideSee also

Copyright © 2010-2012 ARM. All rights reserved.ARM DUI 0452J
Non-ConfidentialID051612