wait

This command instructs the debugger to wait until the target stops. For example, when the application completes or a breakpoint is hit. ARM recommends that you specify a time-out parameter to generate an error if the time-out value is reached.

Show/hideSyntax

wait time-out[ms | s]

Where:

time-out

Specifies the period of time.

ms

Specifies the time in milliseconds. This is the default.

s

Specifies the time in seconds.

Show/hideExample

Example 157. wait

wait 1000                                 # Wait or time-out after 1 second
wait 0.5s                                 # Wait or time-out after half a second

Show/hideSee also

Copyright © 2010-2012 ARM. All rights reserved.ARM DUI 0452K
Non-ConfidentialID071912