reload-symbol-file

This command reloads debug information from an already loaded image into the debugger using the same settings as the original load operation. For example, you can use this command to reload debug information into the debugger after you have rebuilt your image.

Note

The PC register is not set with this command.

Show/hideSyntax

reload-symbol-file [filename]

Where:

filename

Specifies the image to reload. If is not already loaded then an error is generated.

Show/hideExample

Example 92. reload-symbol-file

reload-symbol-file "myFile.axf"                     # Reload debug information

Show/hideSee also

Copyright © 2010-2012 ARM. All rights reserved.ARM DUI 0452L
Non-ConfidentialID100912