1.3.215 unsilence

Enables the printing of stop messages for a specific breakpoint.

Syntax

unsilence [number]

Where:

number

Specifies the breakpoint number. This is the number assigned by the debugger when it is set. You can use info breakpoints to display the number and status of all breakpoints and watchpoints.

If no number is specified then all stop messages are enabled.

Example 1-218 Examples

unsilence 2   # Enable printing of stop messages for breakpoint 2
unsilence $   # This applies to the breakpoint whose number is in 
              # the most recently created debugger variable
Non-ConfidentialPDF file icon PDF versionARM DUI0452Z
Copyright © 2010-2016 ARM Limited or its affiliates. All rights reserved.