1.3.198 step

Steps through an application at the source level stopping on the first instruction of each source line including stepping into all function calls. You must compile your code with debug information to use this command successfully.

You can modify the behavior of this command with the set step-mode command.

Syntax

step [count]

Where:

count

Specifies the number of source lines to execute.

Note:

Execution stops immediately if a breakpoint is reached, even if fewer than count source lines are executed.

Example 1-201 Examples

step                                  # Execute one source line.
step 5                                # Execute five source lines.
Non-ConfidentialPDF file icon PDF versionARM DUI0452Z
Copyright © 2010-2016 ARM Limited or its affiliates. All rights reserved.