1.3.131 set breakpoint

Controls the automatic behavior of breakpoints and watchpoints.

Syntax

set breakpoint [option]

Where:

option

Specifies additional options:

auto-hw

Controls the automatic breakpoint selection when using the break command:

off

Disables automatic breakpoint selection.

on

Uses the memory map attributes to decide if hardware or software breakpoints must be used. This is the default.

auto-remove

Controls the automatic removal of breakpoints and watchpoints when disconnecting from the target:

off

Disables automatic removal.

on

Enables automatic removal. This is the default.

Note:

If the target is running, the debugger temporarily stops the target before removing breakpoints and watchpoints.

skipmode

Controls whether to skip all breakpoints and watchpoints:

off

Disables skip mode. This is the default.

on

Enables skip mode.

Example 1-134 Examples

set breakpoint auto-hw off        # No automatic breakpoint selection
set breakpoint skipmode on        # Skip all breakpoints and watchpoints
set breakpoint auto-remove off    # No automatic removal of breakpoints and watchpoints
Non-ConfidentialPDF file icon PDF versionARM DUI0452Z
Copyright © 2010-2016 ARM Limited or its affiliates. All rights reserved.