1.3.87 loadfile

Loads debug information into the debugger, an image on to the target and records the entry point address for future use by the run and start commands.

The debug information is loaded when required by the debugger.

Note:

This command does not set the PC register.

Syntax

loadfile filename [offset]

Where:

filename

Specifies the image.

offset

Specifies the offset that is added to all addresses within the image.

Example 1-90 Examples

loadfile "myFile.axf"          # Load image and debug information when required
loadfile "images\myFile.axf"   # Load image and debug information when required
loadfile myFile.axf 0x2000     # Load image with offset 0x2000 and load debug
                               # information when required
Non-ConfidentialPDF file icon PDF versionARM DUI0452Z
Copyright © 2010-2016 ARM Limited or its affiliates. All rights reserved.