1.3.200 steps

Steps through an application at the source level stopping on the first instruction of each source statement (for example, statements in a for() loop) including stepping into all function calls. You must compile your code with debug information to use this command successfully.

Syntax

You can modify the behavior of this command with the set step-mode command.

steps [count]

Where:

count

Specifies the number of source statements to execute.

Note:

Execution stops immediately if a breakpoint is reached, even if fewer than count  source statements are executed.

Example 1-203 Examples

steps                              # Execute one source statement.
steps 5                            # Execute five source statements.
Non-ConfidentialPDF file icon PDF versionARM DUI0452Z
Copyright © 2010-2016 ARM Limited or its affiliates. All rights reserved.