11.131 SSAX

Signed parallel subtract and add halfwords with exchange.

Syntax

SSAX{cond} {Rd}, Rn, Rm

where:

cond

is an optional condition code.

Rd

is the destination register.

Rm, Rn

are the ARM registers holding the operands.

Operation

This instruction exchanges the two halfwords of the second operand, then performs a subtraction on the two top halfwords of the operands and an addition on the bottom two halfwords. It writes the results into the corresponding halfwords of the destination. The results are modulo 216. It sets the APSR GE flags.

Register restrictions

You cannot use PC for any register.

You can use SP in ARM instructions but this is deprecated in ARMv6T2 and above. You cannot use SP in Thumb instructions.

GE flags

This instruction does not affect the N, Z, C, V, or Q flags.

It sets the GE flags in the APSR as follows:

GE[1:0]

for bits[15:0] of the result.

GE[3:2]

for bits[31:16] of the result.

It sets a pair of GE flags to 1 to indicate that the corresponding result is greater than or equal to zero. This is equivalent to an ADDS or SUBS instruction setting the N and V condition flags to the same value, so that the GE condition passes.

You can use these flags to control a following SEL instruction.

Note:

GE[1:0] are set or cleared together, and GE[3:2] are set or cleared together.

Architectures

This ARM instruction is available in ARMv6 and above.

This 32-bit Thumb instruction is available in ARMv6T2 and above. For the ARMv7-M architecture, it is only available in an ARMv7E-M implementation.

There is no 16-bit version of this instruction in Thumb.

Non-ConfidentialPDF file icon PDF versionARM DUI0473M
Copyright © 2010-2016 ARM Limited or its affiliates. All rights reserved.