DSTREAM recovery mode

To restore a DSTREAM unit that fails to boot:

  1. Press and hold the reset button on the DSTREAM unit for approximately 10 seconds.

  2. When the STATUS LED flashes red, release the button. The unit is now in recovery mode, and the STATUS LED flashes alternately red and green.

  3. Use the installed Update utility to install a working firmware. The unit then reboots into normal mode.

Note

While in recovery mode, debug and trace operations are not enabled. You must perform a firmware update to restore full functionality.

Show/hideSee also

Copyright © 2010-2012 ARM. All rights reserved.ARM DUI 0481G
Non-ConfidentialID071612