About configuring network settings

The configuration process depends on the way in which the debug hardware unit is connected to the host computer, and whether or not your network uses Dynamic Host Configuration Protocol (DHCP).

If you have connected your debug hardware unit to an Ethernet network or directly to the host computer using an Ethernet cross-over cable, you must configure the network settings before you can use the unit for debugging. You have only to configure the network settings once.

The following connections are possible:

Note

If you have connected your debug hardware unit directly to the host computer using a USB cable, and you do not intend to connect it to a network, you do not have to configure the network settings.

Show/hideSee also

Copyright © 2010-2011 ARM. All rights reserved.ARM DUI 0498D
Non-ConfidentialID071311