Autoconfiguring a scan chain

To autoconfigure a scan chain:

  1. Select the Devices node in the tree diagram.

    If a scan chain configuration is already set up and has a platform assigned to it, autoconfiguration is disabled in RVConfig. If you want to reconfigure the scan chain automatically, click Clear Platform before continuing.

  2. Click on Auto Configure. Each detected device is added to the scan chain configuration list in the control pane, and is also added to the tree diagram. In many cases, this is all that you have to do to configure the scan chain. You must then configure the devices themselves.

  3. If a scan chain configuration is already set up, the following Auto Configure Scan Chain prompt might be displayed:

    Figure 22. Auto Configure Scan Chain dialog box

    Auto Configure Scan Chain dialog box

    Caution

    If you click OK, your current scan chain configuration is lost.

Show/hideSee also

Copyright © 2010-2011 ARM. All rights reserved.ARM DUI 0498D
Non-ConfidentialID071311