Changing the properties of a device

You can change the properties of any device in the scan chain, if required. The properties available depend on the device you are configuring. For example, if you want to capture trace from an ETM, you must make sure the Embedded Trace Macrocell (ETM) option is selected.

To change the properties of a device:

  1. Select the Devices node in the tree diagram.

  2. Select the device in the scan chain configuration list.

  3. Click Properties... to display the Device Properties dialog box. The following figure shows an example:

    Figure 28. The Device Properties dialog box

    The Device Properties dialog box

    Note

    It is not possible to use an ETB without an ETM, so when you select ETB, ETM is selected automatically.

  4. Select the options you require.

    The options available depend on the device you are configuring.

  5. Click OK.

Show/hideSee also

Copyright © 2010-2011 ARM. All rights reserved.ARM DUI 0498D
Non-ConfidentialID071311