Device Properties dialog box

The Device Properties dialog box enables you to change the properties of any device in the scan chain, if required. The following figure shows an example:

Figure 27. The Device Properties dialog box

The Device Properties dialog box

You can:

If no properties are available for a device, the following message is displayed in the Options list

No device options found in current template

Show/hideDevice properties

The device properties listed depends on the device being configured, and can be any of the following:

Embedded Trace Macrocell (ETM)

Select this if you want to capture trace from the ETM.

Embedded Trace Buffer (ETB)

Select this if you want to capture trace from an ETB. You must also select Embedded Trace Macrocell (ETM).

Vector Floating Point (VFP)

Select this to use VFP, if supported.

Vector Floating Point v3 (VFPv3)

Select this to use VFPv3, if supported.

Vector Floating Point v3-D16 (VFPv3-D16)

Select this to use VFPv3-D16, if supported.

NEON SIMD Extensions (Neon)

Select this to use NEON, if supported.

Show/hideSee also

Copyright © 2010-2011 ARM. All rights reserved.ARM DUI 0498D
Non-ConfidentialID071311