The Configure debug_hardware device dialog box

The Configure debug_hardware device dialog box enables you to modify the network settings on a debug hardware unit that has previously been configured. The following figure shows an example:

Figure 3. The Configure debug_hardware device dialog box

The Configure debug_hardware device dialog box

Note

You can modify the settings only for a debug hardware unit that is on your local network or that is connected to a USB port on your PC.

The network settings available depend on whether or not your network uses Dynamic Host Configuration Protocol (DHCP):

Note

The Ethernet Address field is read-only.

After setting up the network settings, click Configure to write the values to the unit.

Click Exit to close the Configure debug_hardware device dialog box

Show/hideSee also

Copyright © 2010-2011 ARM. All rights reserved.ARM DUI 0498D
Non-ConfidentialID071311