The Configure new debug_hardware device dialog box

The Configure new debug_hardware device dialog box enables you to:

The following figure shows an example:

Figure 4. The Configure new debug_hardware device dialog box

The Configure new debug_hardware device dialog box

The network settings available depend on whether or not your network uses Dynamic Host Configuration Protocol (DHCP):

If more than one unit is listed in the browser, click Identify to identify your unit. The Identification LEDs on the selected unit flash for five seconds.

After setting up the network settings, click Configure to write the values to the unit.

Click Exit to close the Configure new debug_hardware device dialog box

Show/hideSee also

Copyright © 2010-2011 ARM. All rights reserved.ARM DUI 0498D
Non-ConfidentialID071311