Determining the correct network settings

Before you can configure the network settings, you must first determine the correct network settings for your debug hardware unit. To do this, you must consult with the system administrator for your network.

The information that you require depends on whether your network uses Dynamic Host Configuration Protocol (DHCP):

Table 1. Required debug hardware network settings

InformationUsing DHCPNot using DHCP
Host NameYesYes
IP Address-Yes
Default Gateway-Yes
Subnet Mask-Yes
Ethernet AddressYesYes
Ethernet TypeYesYes

Show/hideSee also

Copyright © 2010-2011 ARM. All rights reserved.ARM DUI 0498D
Non-ConfidentialID071311