rvigdbconfig command syntax

rvigdbconfig enables you to configure your debug hardware for debugging with GDB.

Show/hideSyntax

rvigdbconfig [-h] [-v] [-d DEVICE:MODE] [-s DEVICE:IP-CONFIG] [-f RVC-FILE]

-d DEVICE:MODE

Set the DCC mode for the device DEVICE to MODE, where MODE can be one of:

0

None (raw DCC)

1

Redirected raw DCC

2

Virtual Ethernet over DCC.

-f RVC-FILE

Load scan chain configuration from RVC-FILE.

-h

Display the command help.

-s DEVICE:IP-CONFIG

Set the DCC mode for the device DEVICE to MODE, where IP-CONFIG is of the form ip-address:subnet-mask:default-gateway.

-v

Print progress messages.

Show/hideExamples

The following are examples of how to use rvigdbconfig:

rvigdbconfig -f rvi.rvc -d 1:2

Sets device 1 (the first device on the scan chain) to DCC mode 2.

rvigdbconfig -f rvi.rvc -d 1:2 -d 2:2

Configures devices 1 and 2 to mode 2.

rvigdbconfig -f rvi.rvc -d 1:2 -s 1:10.0.0.10:255.255.255.0:10.0.0.1

Sets up the IP parameters for static IP configurations. This configures device 1 to use DCC mode 2 with IP address 10.0.0.10, subnet mask 255.255.255.0, and default gateway 10.0.0.1.

rvigdbconfig -f rvi.rvc -d 1:2 -d 2:2 -s 1:10.0.0.10:255.255.255.0:10.0.0.1 -s 2:10.0.0.11:255.255.255.0:10.0.0.1

Sets up IP parameters for multiple processors.

Show/hideSee also

Copyright © 2010-2012 ARM. All rights reserved.ARM DUI 0498G
Non-ConfidentialID071612