Configuring the debug hardware Advanced settings

The Advanced settings enable you to change the global configuration settings for the debug hardware unit. Such settings include debug connection mode settings and reset settings.

To configure the Advanced settings:

  1. Open the Debug Hardware Config utility.

  2. Either:

    • connect to and configure a debug hardware connection to create a new configuration file

    • open an existing debug configuration file.

  3. Select the Advanced settings group in the tree control to display the settings. The following figure shows an example:

    Figure 34. Displaying the advanced controls

    Displaying the advanced controls

  4. Make the changes to the settings as required.

  5. Select Save from the File menu to save your changes.

  6. Select Exit from the File menu to close the Debug Hardware Config utility.

Note

These settings are sent to a debug hardware unit whenever you connect to the unit from a debugger. They are used as the default reset behavior for all target hardware that you debug with that debug hardware unit.

Show/hideSee also

Tasks
Reference

ARM DSTREAM™ System and Interface Design Reference:

ARM RVI™ and RVT™ System and Interface Design Reference:

Copyright © 2010-2012 ARM. All rights reserved.ARM DUI 0498G
Non-ConfidentialID071612