ICs containing multiple devices

If your ASIC contains multiple devices that have a JTAG Test Access Port (TAP) controller, you must serially chain them so that can communicate with all of them simultaneously. The chaining can either be within the ASIC, or externally.

Note

There is no support in DSTREAM for multiplexing TCK, TMS, TDI, TDO, and RTCK between a number of different processors.

Show/hideTAP controllers serially chained within the ASIC

The JTAG standard originally described serially chaining multiple devices on a PCB. This concept can be extended to serially chaining multiple TAP controllers within an ASIC, as shown in the following figure:

Figure 6. TAP Controllers serially chained within an ASIC

To view this graphic, your browser must support the SVG format. Either install a browser with native support, or install an appropriate plugin such as Adobe SVG Viewer.


This configuration does not increase the package pin count. It does increase JTAG propagation delays, but this impact can be small if you put unaddressed TAP controllers into bypass mode.

Show/hideTAP controllers serially chained externally

You can use separate pins on the ASIC for each JTAG port, and serially chain them externally (for example on the PCB). This configuration can simplify device testing, and gives the greatest flexibility on the PCB. However, this is at the cost of many pins on the device package.

Show/hideSee also

Copyright © 2010-2011 ARM. All rights reserved.ARM DUI 0499D
Non-ConfidentialID071311