About the MIPI 34 connector

The MIPI 34 connector can be used in either standard JTAG (IEEE 1149.1) mode or Serial Wire Debug (SWD) mode. It can also capture up to 4-bits of parallel trace in Trace Port Interface Unit (TPIU) continuous mode.

This connector supports separate voltage domains for the debug and trace signals. It is therefore necessary to supply the appropriate voltages to both of the VTREF pins.

The following figure shows the MIPI 34 connector pinout:

Figure 19. MIPI 34 connector pinout

To view this graphic, your browser must support the SVG format. Either install a browser with native support, or install an appropriate plugin such as Adobe SVG Viewer.


Note

A polarizing key is fitted only at the target end of the cable.

Show/hideSee also

Copyright © 2010-2012, 2015 ARM. All rights reserved.ARM DUI 0499I
Non-ConfidentialID031715