ARM® DS-5™ Setting up the ARM RVI™ Hardware

Version 5


List of Tables

1. Diagnostic table

Proprietary Notice

Words and logos marked with or are registered trademarks or trademarks of ARM in the EU and other countries, except as otherwise stated below in this proprietary notice. Other brands and names mentioned herein may be the trademarks of their respective owners.

Neither the whole nor any part of the information contained in, or the product described in, this document may be adapted or reproduced in any material form except with the prior written permission of the copyright holder.

The product described in this document is subject to continuous developments and improvements. All particulars of the product and its use contained in this document are given by ARM in good faith. However, all warranties implied or expressed, including but not limited to implied warranties of merchantability, or fitness for purpose, are excluded.

This document is intended only to assist the reader in the use of the product. ARM shall not be liable for any loss or damage arising from the use of any information in this document, or any error or omission in such information, or any incorrect use of the product.

Where the term ARM is used it means “ARM or any of its subsidiaries as appropriate”.

This product includes software developed by the Apache Software Foundation (see http://www.apache.org).

Confidentiality Status

This document is Non-Confidential. The right to use, copy and disclose this document may be subject to license restrictions in accordance with the terms of the agreement entered into by ARM and the party that ARM delivered this document to.

Product Status

The information in this document is final, that is for a developed product.

Conformance Notices

This section contains conformance notices.

Federal Communications Commission Notice

This device is test equipment and consequently is exempt from part 15 of the FCC Rules under section 15.103 (c).

CE Declaration of Conformity

To view this graphic, your browser must support the SVG format. Either install a browser with native support, or install an appropriate plugin such as Adobe SVG Viewer.

The system should be powered down when not in use.

It is recommended that ESD precautions be taken when handling ARM RVI equipment.

The ARM RVI module generates, uses, and can radiate radio frequency energy and may cause harmful interference to radio communications. There is no guarantee that interference will not occur in a particular installation. If this equipment causes harmful interference to radio or television reception, which can be determined by turning the equipment off or on, you are encouraged to try to correct the interference by one or more of the following measures:

  • ensure attached cables do not lie across the target board

  • reorient the receiving antenna

  • increase the distance between the equipment and the receiver

  • connect the equipment into an outlet on a circuit different from that to which the receiver is connected

  • consult the dealer or an experienced radio/TV technician for help

Note

It is recommended that wherever possible shielded interface cables be used.

Revision History
Revision AMay 2010First release
Revision BNovember 2010Second release
Revision C30 April 2011DSTREAM and RVI v4.2.1 Release
Revision D29 July 2011Update 1 for DSTREAM and RVI v4.2.1
Revision E30 September 2011DSTREAM and RVI v4.4 Release
Revision F29 February 2012Update 1 for DS-5
Revision G29 July 2012Update 2 for DS-5
Revision H12 October 2012Update 3 for DS-5
Copyright © 2010-2012 ARM. All rights reserved.ARM DUI 0515H
Non-ConfidentialID092812