JTAG interface pinouts

The RealView® ICE run control unit is supplied with a short ribbon cable, and a longer ribbon cable and Low Voltage Differential Signaling (LVDS) probe. These both terminate in a 20-way 2.54mm pitch Insulation Displacement Connector (IDC) connector. You can use either cable to mate with a keyed box header on the target. The pinout is shown in the following figure:

Figure 10. JTAG interface pinout

To view this graphic, your browser must support the SVG format. Either install a browser with native support, or install an appropriate plugin such as Adobe SVG Viewer.


Note

All GND pins must be connected to 0V on the target hardware.

Show/hideSee also

Copyright © 2010 ARM. All rights reserved.ARM DUI 0517A
Non-ConfidentialID051610